HySecurity StrongArmCrash Manual Dual-Arm Anti-Ram Barrier Gate - M30
Details
HySecurity StrongArmCrash Manual Dual-Arm Anti-Ram Barrier Gate - M30
The HySecurity StrongArmCrash Manual Dual-Arm Barrier Gate - M30 offers a non-powered anti-ram vehicle barrier arm for secure facilities without electrical infrastructure. This M30 certified crash barrier is manually operated, yet fully tested to halt a 15,000-pound vehicle at 30 mph under ASTM F2656 standards. Its dual-arm layout adds strength and spans wide access points for effective passive security. Ruggedly engineered, it's ideal for remote checkpoints, hardened backup gates, or off-grid sites. Built for longevity in extreme conditions, this hostile vehicle mitigation barrier is a smart choice where reliability matters most.
Key Features:
- Manually operated, no power, motors, or electronics required
- Crash-rated to ASTM F2656-07 M30 P1 standard for secure perimeters
- Dual-arm barrier physically deters vehicle penetration at 30 mph
- Low-maintenance and field-serviceable for remote deployment
- Rated for operation in extreme weather, including -40 degrees F to 158 degrees F
Specifications:
- Crash Rating: ASTM F2656-07 M30 P1
- Drive System: Manual (counterbalance or mechanical assist)
- Open Time: approx. 1-3 minutes depending on arm length
- Close Time: approx. 15-25 seconds
- Full Open Angle: 88 degrees +/- 2 degrees
- Temperature Range: -40 degrees F to 158 degrees F
- Foundation: 6'x6'x4' concrete with #6 rebar, 4000 psi
- Finish: Hot-dip galvanized over zinc plating
Contact HySecurity to request official ASTM F2656-07 M30 and M50 crash test certifications. The StrongArm M50 model achieved a P2 rating, with vehicle penetration limited to 1.17 meters.
SKU | STRONGARMCRASHM30NP |
---|---|
Operator Type | StrongArmCrash |
Crash Rating
Learn More About Crash Ratings
Learn More
|
M30 |
Arm Speed | 60 to 120 Sec. / 15 to 25 Sec. |
Duty Cycle | Manually Operated |
Manufacturer | Nice | HySecurity |
Manual | Download PDF file |
Specification Sheet | Download PDF file |